Genuine Infiniti G35 Fuel Level Sensor

Infiniti G35 Fuel Level Sensor Parts Questions & Answers

• Fuel Gauge Sending Unit
  25060-AL511
  Q: How to Disassemble and Reassemble the Fuel Pump/Fuel Level Sensor Module in Infiniti G35?

  A: To disassemble the fuel pump/fuel level sensor module, begin by separating the fuel level sensor from the fuel pump. Disconnect and separate the assemblies, removing the old outlet pipe 0-ring. If the fuel level or temperature sensor needs replacement, replace the entire unit. To replace the fuel pump, remove the retainer cap and pump from the filter housing, throwing away the rubber grommet. For replacement, remove the fuel pressure regulator and old O-ring. Install the fuel pump, regulator, and sensor assembly. Use a new O-ring and grommet, aligning the outlet pipes. Install the fuel pump, regulator, and sensor assembly with a new O-ring and grommet, aligning the outlet pipes.
• Fuel Gauge Sending Unit
  25060-AM600
  Q: How to remove and replace the Fuel Pump/Fuel Level Sensor Module in a Fuel-Injected engine on Infiniti G35?

  A: Depressurize the fuel system, disconnect the battery, drain the Fuel Tank to 7/8, remove the rear seat and access cover. Disconnect the electrical connector and fuel supply line from the fuel pump module. Clean the area around the retainer, remove bolts, and lift the module to access the crossover tube. Disconnect the tube, remove the module, discard the old 0-ring, check the fuel inlet strainer, discard the old sensor 0-ring, and install a new one when replacing the module.