Infiniti 12310-CD001 FLYWHEEL Assembly

You can Select Your Vehicle to check if 12310-CD001 fits your vehicle.

Raise the vehicle and securely support it on jackstands, then remove the transmission. For vehicles with a manual transmission, remove the pressure plate and clutch disc, taking the opportunity to check or replace the clutch components and pilot bushing if necessary. For those with an automatic transmission, check and replace the front pump seal or O-ring. Use paint or a center-punch to make alignment marks on the flywheel or driveplate and crankshaft to ensure correct alignment during reinstallation. Remove the bolts securing the flywheel or driveplate to the crankshaft, holding the driveplate in place with a lever or screwdriver to prevent it from turning. If the crankshaft rotates, use a pry bar or wedge a screwdriver into the ring gear teeth to jam the flywheel. Carefully remove the flywheel or driveplate, supporting it while removing the last bolt due to its weight. Clean the flywheel to remove grease and oil, inspecting the surface for cracks, rivet grooves, burned areas, and score marks, with light scoring removable using emery cloth. Check for cracked or broken ring gear teeth and ensure the flywheel is flat by using a straightedge. Clean and inspect the mating surfaces of the flywheel or driveplate and crankshaft, replacing the crankshaft rear seal if it is leaking before reinstalling. Position the flywheel or driveplate against the crankshaft, aligning the marks made during removal, and apply thread locking compound to the bolt threads before installation. Wedge a screwdriver into the ring gear teeth to prevent the flywheel or driveplate from turning while tightening the bolts to the specified torque. The remainder of the installation follows the reverse order of removal.