Genuine Infiniti G35 Bumper

Infiniti G35 Bumper Parts Questions & Answers

• Front Bumper Cover
  62022-JK20H
  Q: How do you remove and install a Infiniti G35's bumper cover?

  A: Starting with applying the parking brake; then lifting the car up and placing support jack stands underneath it. Under the vehicle, now, unbolt all the screws that are used to fasten the lower flaps of the bumper cover. At the interior of the vehicle, in the front wheel opening remove the retaining screws that kept the bumper cover affixed to the inner fender well splash shield. Push the lower edge of the splash shield, and there is a nut behind the trim of the bumper cover to remove. In the next step ,seemingly unscrew all the clips holding upper part of the bumper cover in position, after this lifts the bumper cover up and pull it off the car. It is necessary to demate any electrical connections that can hinder the removal process. Perform the procedures implemented at the beginning to set up the parking brake, to lift the automobile, and to apply jack stands. Under the vehicle once more, undo the bolts holding the lower flares of the bumper cover in place again. Inside the trunk, remove the fasteners which hold the rear inside trunk finishing panel, in order to reveal the bumper cover retaining fasteners. Removing the fasteners fixing the bumper to the right and left quarter panel then pulling off the bumper's cover and directing it away from the car. The process of installation, therefore, is a mirror image of the process of removal of the Office suite.